XMG1915 Works fine with ipv4 but ipv6 doesnt get an ip via SLAAC

beekeeper

IPv4 works and switch get an ip out of Vlan99. This ip out of vlan99 is the switch mgt address.

The port1 is defined as pvid=1 and all vlan -including vlan99 - as tagged. The corresponding router port is defined the same way.

A fe80 address is shown at xmg1915 but router cant ping to it and switch cant ping router

Router has advertising for vlan99 active and other clients get their addresses without problems.

How to setup ipv6 to get a running switch ?

Zyxel_Melen

Hi @beekeeper

Did you enable "Address Autoconfig" for VLAN99 in IPv6 Interface Setup? I enable this in my lab and my device can get the SLAAC IP and ping to the uplink router (both interface IP and fe80(link local IP)). If you enable it but can't get SLAAC IP, you will need to check your router's setting for the RA part.

You might also need to check the uplink device's security policy setting.