I want to exclude my AP from all Nebula services and run it locally in standalone mode

Options
Zyxel_JoyLee
Zyxel_JoyLee Posts: 244
Friend Collector First Anniversary
image  Zyxel Employee

When an access point is managed by Zyxel Nebula, it operates in "cloud mode," where its configuration is primarily controlled by the Nebula Control Center.

When you delete the device from Nebula, it doesn't always immediately revert to a full standalone mode with all local management options unlocked.

The device may still be in a state expecting cloud management, which can lead to a limited local web interface.

To fully transition your AP from Nebula cloud management back to a complete standalone mode with all configuration options available, a factory reset is typically required.

Here's why and what you should do:

  1. Cloud Mode vs. Standalone Mode: Devices managed by Nebula have their settings pushed from the cloud. When removed from Nebula, they might retain remnants of their cloud configuration or be in a transitional state, preventing full standalone access.
  2. Factory Reset: A factory reset will erase all configurations, including any lingering cloud settings, and restore the device to its original out-of-the-box state. This is often the necessary step to regain full local management capabilities.
    • How to Factory Reset: Typically, you can perform a factory reset by holding down the physical reset button on the access point for about 10-15 seconds while the device is powered on. Consult your device's manual for the exact procedure.
  3. Accessing Standalone GUI: After a successful factory reset, the access point will boot up in standalone mode. You should then be able to access its full local web GUI using its default IP address (often 192.168.1.1, but check your device's manual) and default credentials (e.g., admin/1234).

Once the device is factory reset, you should find the standalone menu to be fully functional, allowing you to configure all settings locally.