Zywall 100 lost configuration
After power off my Zywall 100 lost last configuration and start with "last good". Because always after some changes I save config I try start Zywall with backup config: Zywall find some problems in it and back to "last good". How can I check what is wrong in this config?
0
All Replies
-
Hi @Leszek,
Connect the serial console between ZyWALL and one laptop.
Use the commands to apply your backup configuration file.
If it failed to apply the backup configuration file, you'll find the reason in "ERROR:".
Router# configure terminal
Router(config)# apply /conf/test_backup.conf
Best regards,
EmilyDon't miss this great chance to upgrade your Nebula org. For free!
0 -
Hiwe tested it and finally there was no error on the terminal but new config did not load. There was a additional restart during loading new config and Zywall had old one "last good".But we found a solution: we use the load via HTTP with option "...ignoring errors" and it's working.
1
Categories
- All Categories
- 414 Beta Program
- 2.2K Nebula
- 130 Nebula Ideas
- 91 Nebula Status and Incidents
- 5.4K Security
- 175 USG FLEX H Series
- 256 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 36 Wireless Ideas
- 6.2K Consumer Product
- 235 Service & License
- 372 News and Release
- 79 Security Advisories
- 24 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 81 About Community
- 69 Security Highlight