USG not comunicate with specified IP address

RaphaelOIiveria
Posts: 35
Freshman Member





Hi,
This is my case.
We have a rang of WAN IPs (Ex: 192.168.0.96-255.255.255.248)
If I configure WAN1 or WAN2 or WAN sub-interface with the IP 192.168.0.98 this ip not work, I can't ping internali this IP, but if I configure other IP address range (97,99-101) my USG work well.
Some one has ideia about this?
This is my case.
We have a rang of WAN IPs (Ex: 192.168.0.96-255.255.255.248)
If I configure WAN1 or WAN2 or WAN sub-interface with the IP 192.168.0.98 this ip not work, I can't ping internali this IP, but if I configure other IP address range (97,99-101) my USG work well.
Some one has ideia about this?
0
All Replies
-
The mensage bellow is show when a ping the ip .98
ping: sendmsg: Operation not permitted
0 -
Hi @RaphaelOliveira,
For some ISP, some IP addresses are used for access link only, not for data link.
When you configure 192.168.0.98 in wan1, use the following command on web console to check the ping result.
Router# ping 8.8.8.8 interface wan1
Before entering the command, capture packets on wan1 interface and filter by icmp.
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 172 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 406 USG FLEX H Series
- 296 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 268 Service & License
- 413 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight