USG 40 - SSL VPN - disable multiple connection for user
Hi,
we're using SSL VPN to connect to a USG40.
Some users forget to click on disconnect after using the VPN and so, until the reauthentication Time is reached, sometimes it happens that a user connects again and the SSL VPN tunnels get all occupied soon with same users connected multiple times. Is it possible to prevent this?
Thank you
Kari
All Replies
-
For each user you can set lease time to 2 minutes and in User/Group > settings you can check Enable user idle detection
0 -
The reduced lease time will renew if the user stays connected.
0 -
How the USG conduct the idle detection, by scanning packets which are going through the tunnel? But a few packets will be transmitted through the SSL VPN tunnel also always without any user action.
We are using a lot of SSL VPN tunnels, and when established, using RDP sessions to our office computers. Will this be detected by the USG as "not idle"?
0 -
Oddly that "Reach maximum number per account" setting is not in USG40
0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 91 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 920 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 931 Nebula FAQ
- 423 Security FAQ
- 238 Switch FAQ
- 210 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight