How to properly limit bandwidth on GS1910-48 switch?
Options
Freshman Member
Hello Folks.
I am trying to limit the bandwidth on my switch ports to 250Mbits.
The problem is that when i apply the limitation on ports, the servers connected to it get packet loss. Even if they are consuming only 20Mbits.
I am sure that i am doing something wrong...
This is only the configuration i did (i didn't touched anything else):
I am trying to limit the bandwidth on my switch ports to 250Mbits.
The problem is that when i apply the limitation on ports, the servers connected to it get packet loss. Even if they are consuming only 20Mbits.
I am sure that i am doing something wrong...
This is only the configuration i did (i didn't touched anything else):
0
All Replies
-
Hi @Webix
In GS1910 series, ingress rate limiting mainly takes effect on UDP packet, but not accurate for non-UDP ones due to chip limitations.
By the way, GS1910 series is very old model which is EoL already, so there might be problems will not be fixed.
Zyxel_Lucious0
Zyxel Employee
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 228 Nebula Ideas
- 130 Nebula Status and Incidents
- 6.6K Security
- 648 USG FLEX H Series
- 357 Security Ideas
- 1.8K Switch
- 86 Switch Ideas
- 1.4K Wireless
- 55 Wireless Ideas
- 7.1K Consumer Product
- 304 Service & License
- 496 News and Release
- 94 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5K FAQ
- 34 Documents
- 89 About Community
- 110 Security Highlight
