Hot fix for CVE-2020-29583 is available now

Zyxel_Dick
Posts: 21
Zyxel Employee




Comments
-
We've tried updating our NXC2500 from V6.10(AAIG.0) to V6.10(AAIG.1) two times. In both cases the controller does not boot after the update. The SYS led is red. After a power cycle the controller still works, but the firmware is reverted to the old version V6.10(AAIG.0). Any tips?0
-
Hi @RhvO ,
May I know is there any log shown in NXC2500 about the firmware upgrade failed? Would you collect the diagnostic and PM to me to check the detail of the upgrading issue?
Thanks.0 -
Hi @RhvO
Would you mind to upgrade the firmware via FTP which will transfer the firmware image faster? Enable the FTP service for this time, and follow the below steps to upgrade the FTP firmware.
After finishing updating, disable the FTP service if you are worried about the impact.
Joslyn0 -
Thank you for help. We do not get any information in the logs. We will try the ftp method.0
Categories
- All Categories
- 192 Beta Program
- 1.7K Nebula
- 93 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 920 WirelessLAN
- 28 WLAN Ideas
- 5.4K Consumer Product
- 174 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 453 Nebula FAQ
- 258 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight