Commands in CLI User mode crash WAX650S
GuestUser
Posts: 2
Hello there,
The following commands, when run in CLI User Mode systematically crash my WAX650S:
The following commands, when run in CLI User Mode systematically crash my WAX650S:
Router> show reference object-group aaa ad ==== ZySH daemon is dead ==== Router> show reference object-group aaa ldap ==== ZySH daemon is dead ====
<br>
The AP reboots after these two commands.
Tested with:
- admin and limited-admin users
- firmware v6.00 and v6.10
- SSH
I don't currently use ad nor ldap.
Tested with:
- admin and limited-admin users
- firmware v6.00 and v6.10
- SSH
I don't currently use ad nor ldap.
0
Accepted Solution
-
Hi @GuestUser
Since the commands are not using in standalone mode so the issue raises after entering, we’ll do an enhancement that disable the commands to prevent. Thank you for your post again.
Regards,
Bella
0
All Replies
-
.0
-
Hi @GuestUser
Thank you for your post of concerning the issue.
We're investigating and will reply you if any update.
Regards,
Bella
0 -
Hi @GuestUser
Since the commands are not using in standalone mode so the issue raises after entering, we’ll do an enhancement that disable the commands to prevent. Thank you for your post again.
Regards,
Bella
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight