USG60 Wishing to block an IP Range - How to?
Options
All Replies
-
Content Filter needs to be activated for Geo-ip to work.
On the Address click add
name = name
address type = GEOGRAPHY
region = select one
Then go to security policy > policy control add
name = name
from = WAN
To = LAN1?
Source = your above Geo-ip object
action = deny
1 -
Thank for that.I believe we subscribe to content filter?In fact to:Could it not be activated?
Anti-Spam Gateway Anti-Virus_Bitdefender Signature Content Filter IDP SecuReporter Premium
0 -
In Licensing > Registration > service tab does it say "Activated" for Content Filter 2.0?
Have you updated the Country Database in Geo IP
0 -
Hi, Yes, all 5 are actviated.The country database is up to date and set to autoupdate.It was the IP range I set in the section 'Custom IPv4 to Geography Rules' that did not seem to work.
0 -
Hi @Blobby123,
Did you try to create Address range object and assign it to a Security Policy rule?
1- Create address range object (Configuration > Object > Address/Geo IP)
2- Assign it to a Security Policy rule (Configuration > Security Policy > Policy Control)
Also, please make sure Policy Control is enabled (Configuration > Security Policy > Policy Control)
0
Categories
- All Categories
- 393 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 906 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight