USG60 High CPU
Options
I recently upgraded my Spectrum Internet from 100 mbps to 600. If I set the USG60 Wan1 interface to 1G, the firewall CPU will go to 100% after a short period of time and become unresponsive. If I set the Wan1 to 100 mbps, it runs without issue. I'm not able to control the speed on the Spectrum device--its fixed to auto. Any one have a resolution?
0
All Replies
-
Hi @Dayna,
Can you share some information with us;
1- What’s the firmware version of USG60?
2- Can you type following command to console when this issue occurs and share with me by private message :
Router# debug system top iterations 5
Router# debug system ps
Router# show cpu average
You can also find following forum entry as reference and share information with us:
0 -
The firmware version is 4.62 . Over the weekend, support shipped me an RMA replacement unit which I put in place and has been running for 3 days without the same issue occurring.0
Categories
- All Categories
- 393 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 906 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight