Can't Access GS1900-24HP After Firmware Upgrade on the Network
Options
zyxeluser100
Posts: 2
I just updated to the latest firmware on a GS1900-24HP that I purchased in 2015. After resetting, the admin credentials would not authenticate and I could not login. The release notes mentioned an algorithm change, so I reset the switch (Held down the button on the front 10 seconds and the unit power cycled). Now, the switch does not come up a network as 192.168.1.1 on the network. I've reset it 3 or 4 times now, and no dice. The switch still functions as a switch, but it won't come on the network as 192.168.1.1. Is there any recourse? It doesn't look like this model has a COM port.
0
Accepted Solution
-
Did you look for a "not expected" IP address on your DHCP server?
0
All Replies
-
Did you look for a "not expected" IP address on your DHCP server?
0 -
Ha! thanks, that found it. Seems so obviously after the fact.
0 -
It was one of the options, the Switch did not keep up the configured Ip and went into DHCP mode... :-)
0 -
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 52 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight