vlan
Options
Freshman Member
Accepted Solution
-
Hello @baudetd,Welcome to Zyxel community.As @PeterUK suggested, please go to Configuration > Security Policy > Policy Control, and edit LAN2_Outgoing policy, change the "To:" option to from Any to WAN. This change will allow the LAN2 to communicate with the internet and not other internal interfaces.Thank you.
James0
Zyxel EmployeeAll Replies
-
Ok you mean lan2 (p4) then you need to make sure policy control from LAN2 is set to WAN not any.
0 -
Hello @baudetd,Welcome to Zyxel community.As @PeterUK suggested, please go to Configuration > Security Policy > Policy Control, and edit LAN2_Outgoing policy, change the "To:" option to from Any to WAN. This change will allow the LAN2 to communicate with the internet and not other internal interfaces.Thank you.James0
-
hi,
ok it's good !
can you tell me more about the différent pages (,is there a doc?
how could you also limit the flow on lan2 ?
version firmware is 4.35 , it's time to update!
0 -
Hello @baudetd,Do you mean BWM(Bandwidth Management)?Please go to Configuration > BWM, enable BWM and create a profile for LAN2 interface. Select lan2 as Incoming Interface and LAN2_subnet as Source, then customize the limitation such as bandwidth Shaping.
You may refer to our knowledge base articles or handbook page 788 for more.James0
Guru MemberCategories
- All Categories
- 442 Beta Program
- 3.1K Nebula
- 242 Nebula Ideas
- 6.8K Security
- 779 USG FLEX H Series
- 387 Security Ideas
- 1.8K Switch
- 87 Switch Ideas
- 1.5K Wireless
- 58 Wireless Ideas
- 7.2K Consumer Product
- 324 Service & License
- 527 News and Release
- 101 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5.3K FAQ
- 34 Documents
- 91 About Community
- 121 Security Highlight
