ZYSH daemon terminates. Restart daemon using telnet?

InterLAN
InterLAN Posts: 9  Freshman Member
First Comment Fourth Anniversary
edited April 2021 in Security
On a USG310 ( V4.25(AAPJ.1)C0), the ZYSH terminates unexpectedly while editing GEO-groups. 
If the firewall is rebooted, ZYSH starts again. However, rebooting is unacceptable due to the interruption of service.
How can I can start the ZYSH daemon from Telnet without rebooting? 

Comments

  • InterLAN
    InterLAN Posts: 9  Freshman Member
    First Comment Fourth Anniversary
  • jasailafan
    jasailafan Posts: 193  Master Member
    5 Answers First Comment Friend Collector Sixth Anniversary
    I got the same issue on ZyWALL 110 before.
    When I try to modify the address group object, the error message pops up "Zysh Daemon is terminated".
    Then the local support gave me the date firmware and the issue is resolved.

  • Zyxel_Charlie
    Zyxel_Charlie Posts: 1,034  Zyxel Employee
    50 Answers 500 Comments Friend Collector Fourth Anniversary
    Hello InterLan,
    We suggest to upgrade your device’s FW to the latest one firstly, this issue should had been fixed on this FW version.
    The download link will be PM to you.
    Charlie 
  • InterLAN
    InterLAN Posts: 9  Freshman Member
    First Comment Fourth Anniversary
    The issue was resolved by an interim release firmware upgrade. 
    Thank you, Charlie
  • jkeane
    jkeane Posts: 4  Freshman Member
    First Comment Fifth Anniversary
    I'm running into this same issue.   USG60, v4.25(AAKY.1).  I was able to upload a new conf file with the changes to my Address Groups.  Is there an available patch?
  • Zyxel_Charlie
    Zyxel_Charlie Posts: 1,034  Zyxel Employee
    50 Answers 500 Comments Friend Collector Fourth Anniversary
    @jkeane
    I will private message the firmware to you. Please has a check.
    Charlie

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）