ATP800 to USG Flex 700H Issues

NEP · August 27

Hello,

We just picked up a 700H to replace an ATP800. Happened to find the migration website and tried converting the config. Got nothing usable out of it. The CONF output is all commented out. Granted the config could be considered slightly complex, so I tried an ATP200 config which is as basic as it gets. One interface, two VLANs, and some reserved IPs. That produced a config that was all comments as well.

Below is a list of some of the issues that the log reported. None of them appear to be in the list of Unsupported Features. The converter "Finished" for the ATP200 but "Stopped" for the ATP800. However, both show "Manual Action Required" and neither have anything but commented lines in the CONF file.

[CRITICAL-001]
Reason : Validator check failed: IKE VPN "vpn4": configuration is invalid or could not be converted
Action : Resolve the blocking issue before deployment.

[VALIDATION-003]
Line : 1040
CLI : vpn-name vpn12 sp-name vpn12 crypto map vpn12 adjust-mss auto
Reason : The command failed and no safe default value was available.
Action : Review the original CLI and fix the invalid value or dependency manually.

[SCOPE-004]
Line : 12
CLI : interface-name ge2 wan1
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.

[SCOPE-010]
Line : 64
CLI : port-grouping lan1
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.

[SCOPE-018]
Line : 80
CLI : ip dhcp pool 192.168.12.0/24
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.
[SCOPE-025]
Line : 103
CLI : ip dhcp pool 192.168.12.0/24 host 192.168.12.52
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.

[SCOPE-034]
Line : 114
CLI : ip dhcp pool 192.168.12.0/24 hardware-address B0…
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.

[SCOPE-2729]
Line : 4300
CLI : utm-manager dns-content-filter defaultport 53
Reason : No mapped CLI is available on the target platform.
Action : Review and configure this command manually if still required.

Is the conversion tool get broken? Or am I doing something wrong? Thanks.