USG FLEX 700 & Network > Interface > Port > Port Group
Hello,
There seems to be a "new" way to setup Port Grouping on the USG FLEX 700 that I can't find covered in the USG FLEX 700_V5-00_Ed1 Users Guide. I am familiar with the dots across the screen under the Ports and clicking to assign the Grouping but this new graphic has me a bit stumped.


With the drag-drop I have done in the pic do I now go and configure the "geX" ports of ge4 ge5 ge6 -or- only ge5.
Thanks.
-stew
There seems to be a "new" way to setup Port Grouping on the USG FLEX 700 that I can't find covered in the USG FLEX 700_V5-00_Ed1 Users Guide. I am familiar with the dots across the screen under the Ports and clicking to assign the Grouping but this new graphic has me a bit stumped.

With the drag-drop I have done in the pic do I now go and configure the "geX" ports of ge4 ge5 ge6 -or- only ge5.
Thanks.
-stew
0
Accepted Solution
-
You only need to configure ge5as P4,P5 and P6 are now linked to ge51
Categories
- 8.1K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 224 Security Ideas
- 965 Switch
- 45 Switch Ideas
- 868 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 139 Service & License
- 268 News and Release
- 53 Security Advisories
- 12 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight