USG60 ipsec to Lan2
Hi
I have a USG60 firmware 4.62 with site to site vpn on Lan1.
I want to setup ipsec IKEV2 server to client, vpn that route traffic only to Lan2.
local policy IPSEC range is 100.100.100.1 - 100.100.100.20
I can connect, but not ping or access lan2.
/Tony
I have a USG60 firmware 4.62 with site to site vpn on Lan1.
I want to setup ipsec IKEV2 server to client, vpn that route traffic only to Lan2.
Lan1 network is 176.26.11.0
Lan2 network is 192.168.41.0local policy IPSEC range is 100.100.100.1 - 100.100.100.20
I can connect, but not ping or access lan2.
/Tony
0
Accepted Solution
-
@ITB_Tony
According to your description, you can refer to the following IKEv2 VPN configuration that can be verified successfully at our lab.
Configuration > VPN > IPsec > VPN Gateway
Configuration > VPN > IPsec > VPN Connection
Establishing IKEv2 VPN connection and navigate Monitor > VPN Monitor > IPsec > to see if IKEv2 VPN IP belongs to the LAN2 domain.
1
All Replies
-
Thx works good
, i have missed the "configuration Payload" option.
1
Categories
- 8.1K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 224 Security Ideas
- 965 Switch
- 45 Switch Ideas
- 868 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 139 Service & License
- 268 News and Release
- 53 Security Advisories
- 6 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight