USG 110 - clear port statistics
Options
AWUSupport
Posts: 43 Freshman Member
Does anyone know the CLI command to clear port statistics - in our case Ethernet Port5?
I think it along the lines of interface reset however cannot get the correct syntax.
I think it along the lines of interface reset however cannot get the correct syntax.
0
Comments
-
@AWUSupport
The Port statistics can not be reset or clean via CLI, however, the statistics can be reset after you plug network cable out and plug it in.
Charlie0 -
Charlie,
Can you review this snip from a CLI Reference Guide - seems to suggest it can be done however I am uncertain as to correct syntax.
0 -
@AWUSupport
It seems there is miscommunication:). Initial request is "clear port statistics ", so I informed you need to plug network cable out-in.
(physical Port and Interface are different. One port can be separated to numbers of interface )Yes, we can do rest interface via CLI. Please check as below.
Enter "show interface summary all status" to check all interface status, and enter "interface reset wan1" to reset wan1 interface.
Charlie
0 -
That is true, clear port statistics is what we were after however we were hoping if all interfaces were cleared then maybe this would clears the port used by those interfaces. Seems our hopes were in vain. Thanks for your help.0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 76 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 896 Nebula FAQ
- 415 Security FAQ
- 233 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight