SD WAN - Setup Router Configuration
Hi we have two offices one in LA on in London.
I ahve set up the SD-WAN cloud stuff and have the units display there.
If however we reset the uinits to factory default surely we don't have to set up all the firewall's again ?
Can we migrate the config somehow ?
I ahve set up the SD-WAN cloud stuff and have the units display there.
If however we reset the uinits to factory default surely we don't have to set up all the firewall's again ?
Can we migrate the config somehow ?
0
All Replies
-
Hi @Orbital
After reset your device, then device configuration will become to standalone.
It means you have to re-configure device if you would like keep it as standalone mode.
If you would like turn back device as SDWAN mode, then you have to re-ZTP again.
Before ZTP, you have to un-link your device from your site first.
The old configuration will exist on cloud, device will download configuration from Orchestrator after ZTP completely.0
Categories
- All Categories
- 426 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 346 USG FLEX H Series
- 290 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight