VPN traffic in only 1 direction
I have 2 sites connected via site to site VPN but I am only able to send traffic in 1 direction between sites. It connects so I know it's not a VPN issue. The site that cannot send has a new router so I don't think it's a stray rule somewhere but I am at a loss. Any ideas what I should be looking for?
0
All Replies
-
Do both ends have different LAN subnets?
If you ping from one end do your see any blocked traffic in the logs?0 -
While doing further troubleshooting I discovered that something was wrong with the Firewall on the remote system. I managed to screw it up while testing to the point of HW reset. I had an older config that works so I am good.
0 -
@PeterC
Everything is fine now?
As PeterUK mentioned, you may make sure both ends are located in different subnet.
You can do the packet capture of wan and lan on both device or on the log page to see where block the traffic
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 402 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight