Daylight-saving-time offset not at the defined time?
Options
This weekend the daylight saving time became active and the USG has switched its time. Our settings are: switch the time on last sunday in March at 2:00, offset 1 h.
But the log diagrams (see e.g. session log below) show an offset between 00:00 and 01:00 a clock but not from 02:00 to 03:00.

But the log diagrams (see e.g. session log below) show an offset between 00:00 and 01:00 a clock but not from 02:00 to 03:00.

0
Comments
-
@USG_User
I tested it locally without any issue. You may check the time on the log diagram immediately after you configured daylight saving time.
From my daylight-saving settings where you can see that the USG should add 1 hour offset at 17:35. On the log diagrams show the time was modified to daylight-saving time.
Time Offset
Charlie0 -
Thanks for your effort. I try to repeat a daylight saving during next days. Unfortunately this is our production system where I'm not able to do special tests during office hours. I come through again when I have new results.
Joerg
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight