Daylight-saving-time offset not at the defined time?

Options
USG_User
USG_User Posts: 369  Master Member
First Anniversary 10 Comments Friend Collector First Answer
edited April 2021 in Security
This weekend the daylight saving time became active and the USG has switched its time. Our settings are: switch the time on last sunday in March at 2:00, offset 1 h.
But the log diagrams (see e.g. session log below) show an offset between 00:00 and 01:00 a clock but not from 02:00 to 03:00.


Comments

  • Zyxel_Charlie
    Zyxel_Charlie Posts: 1,034  Zyxel Employee
    First Anniversary Friend Collector First Answer First Comment
    Options
    @USG_User
    I tested it locally without any issue. You may check the time on the log diagram immediately after you configured daylight saving time.
    From my daylight-saving settings where you can see that the USG should add 1 hour offset at 17:35.  On the log diagrams show the time was modified to daylight-saving time.

    Time Offset


    Charlie
  • USG_User
    USG_User Posts: 369  Master Member
    First Anniversary 10 Comments Friend Collector First Answer
    Options
    Thanks for your effort. I try to repeat a daylight saving during next days. Unfortunately this is our production system where I'm not able to do special tests during office hours. I come through again when I have new results.
    Joerg

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）