Email to SMS on USG110
I have a USG110 running 4.65.
I'm trying to set up MFA via SMS for VPN access and am running into a problem with the user setup. The system sends SMS messages correctly, but when I go to enter a phone number and click 'Send Code' to set up the user under Object->User/Group it sends a blank message - I never get the code.
Is there a setting I'm missing somewhere or is this a bug?
I'm trying to set up MFA via SMS for VPN access and am running into a problem with the user setup. The system sends SMS messages correctly, but when I go to enter a phone number and click 'Send Code' to set up the user under Object->User/Group it sends a blank message - I never get the code.
Is there a setting I'm missing somewhere or is this a bug?
0
Best Answers
-
Hi @BMS,
Please upgrade the firmware to the current forum release which should resolve the symptom you met:
https://community.zyxel.com/en/discussion/11213/zld-v5-02-4-65-wk28-firmware-release
0
All Replies
-
That did resolve the issue. How long until that is a general release?
0
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 35 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 722 Switch
- 30 Switch Ideas
- 598 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 507 FAQ
- 232 Nebula FAQ
- 117 Security FAQ
- 72 Switch FAQ
- Network Reliability
- Network Security
- IPTV
- Layer 3 Switching & Routing
- Surveillance / ONVIF
- Other Topics
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight