How to Route only one FQDN (tv.yousee.dk) through WAN2 (USG60W) - Policy Route
I have two Internet Connection WAN1 (Fast) - WAN2 (Slow -but with television streaming)
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
0
Comments
-
Hi @Kristian,
Do you add a policy route for "tv.yousee.dk" traffic and move to priority one? the configuration as below,
SRC=Lan , DST = tv.yousee.dk IP address 80.62.121.94.
If it is still not work as expected, please post the this CLI result.
Router> show policy-route
1 -
Bingo! It works!
But I think I did the same, but probably not.
You are todays hero ;-) Thank You :-)
0
Categories
- 7.7K All Categories
- 1.6K Nebula
- 53 Nebula Ideas
- 53 Nebula Status and Incidents
- 4.3K Security
- 215 Security Ideas
- 903 Switch
- 40 Switch Ideas
- 793 WirelessLAN
- 14 WLAN Ideas
- 5K Consumer Product
- 129 Service & License
- 260 News and Release
- 49 Security Advisories
- 6 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 67 About Community
- 40 Security Highlight