How to Route only one FQDN (tv.yousee.dk) through WAN2 (USG60W) - Policy Route
I have two Internet Connection WAN1 (Fast) - WAN2 (Slow -but with television streaming)
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
0
Comments
-
Hi @Kristian,
Do you add a policy route for "tv.yousee.dk" traffic and move to priority one? the configuration as below,
SRC=Lan , DST = tv.yousee.dk IP address 80.62.121.94.
If it is still not work as expected, please post the this CLI result.
Router> show policy-route
1 -
Bingo! It works!
But I think I did the same, but probably not.
You are todays hero ;-) Thank You :-)
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight