USG210 NAT 1:1 howto
Hi,
I have one provider and multiple public IPs. One of it is zywall address.
When i whant to take some ports outside i do new NAT 1:1 port mapping to one of my IPs (not default). When i go to my server from the internets all is ok, but when i go outside, using this server, i go with zywall ip. I create new virtual wan with the address that is used by my server. Same result. Why?
I have one provider and multiple public IPs. One of it is zywall address.
When i whant to take some ports outside i do new NAT 1:1 port mapping to one of my IPs (not default). When i go to my server from the internets all is ok, but when i go outside, using this server, i go with zywall ip. I create new virtual wan with the address that is used by my server. Same result. Why?
0
Accepted Solution
-
the problem was in routing)0
Categories
- 8.1K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 224 Security Ideas
- 963 Switch
- 45 Switch Ideas
- 868 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 139 Service & License
- 268 News and Release
- 53 Security Advisories
- 12 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight