Bridging VLAN with physical port

2»

All Replies

  • This is my config. I see you use general interfaces, while I have internal. Could it be the case?


  • I have the "internal" interface types, however switching to general did not help either.
  • Fred_77
    Fred_77 Posts: 118  Ally Member
    100 Comments Third Anniversary First Answer Friend Collector
    Really weird behavior.
    The only differences i can see are:
     i created a new zone "Br1 Zone" and all the interfaces have an ip address (base port, vlan etc..).
    Time ago a guy from zyxel told me don't leave 0.0.0.0 when you have multiple virtual interfaces on the same port 
  • To amend this, did not help. If I remove VLANs from the equation, the bridge works. With VLANs, not at all ....
  • PeterUK
    PeterUK Posts: 3,164  Guru Member
    Community MVP 2500 Comments Sixth Anniversary 100 Answers
    edited April 2022

    If a interface or bridge don't need a IP what I do is set them up with a 127.255.0.0/30

    A layout drawing with IP's might help? 

  • Well, did not help. I have suspicion there is a problem with how the bridge handles tagging...
  • Fred_77
    Fred_77 Posts: 118  Ally Member
    100 Comments Third Anniversary First Answer Friend Collector
    It shouldn't be that.
    I quote PeterUK, could you post a layout with IP's?
  • WJS
    WJS Posts: 155  Master Member
    100 Comments Second Anniversary Friend Collector 5 Answers
    Agree PeterUK, Could you post layout IP?

Security Highlight