IPSEC VPN Site to Site and specific destination ip
I have to configure an IPSEC VPN Site to site from my ATP 500 (on the left) to a custumer network (on the right)


I have been able to setup the VPN Gateway and connection but the customer requests that the computer of my LAN must appear to his network as using a specific ip that the customer give to me:174.100.4.24
Is there a way to do this in the ATP 500 IPSEC VPN configuration?
Thanks in advance.
0
Accepted Solution
-
Hi @xkp68
You can have a try to configure "Outbound Traffic SNAT" and "Inbound Traffic Destination NAT in VPN connection advanced setting.
0
Categories
- 8.5K All Categories
- 1.6K Nebula
- 71 Nebula Ideas
- 57 Nebula Status and Incidents
- 4.5K Security
- 226 Security Ideas
- 983 Switch
- 46 Switch Ideas
- 874 WirelessLAN
- 22 WLAN Ideas
- 5.1K Consumer Product
- 157 Service & License
- 280 News and Release
- 59 Security Advisories
- 13 Education Center
- 580 FAQ
- 263 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 74 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 46 Security Highlight