Client to Site VPN using NAT
Good evening,
I've a probelm setting up a client to site VPN with NAT (I've one public IP address).
I've configured all rules (configuration provisioning, security policy and routing policy), but when I try to connect to my office with IPSEC VPN software and dowloaded relaive config from the firewall, I can't establish connection (software hang on phase 1 and then the connection drops).
Can anyone help me?
My hardware is a ZyWall USG 210.
Thanks
I've a probelm setting up a client to site VPN with NAT (I've one public IP address).
I've configured all rules (configuration provisioning, security policy and routing policy), but when I try to connect to my office with IPSEC VPN software and dowloaded relaive config from the firewall, I can't establish connection (software hang on phase 1 and then the connection drops).
Can anyone help me?
My hardware is a ZyWall USG 210.
Thanks
0
All Replies
-
This section is the same as others, so let's follow up it by other section.0
Categories
- All Categories
- 428 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 348 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight