STP topology changes
Options
Guys, good morning!
We have a switch Zyxel GS2220-50HP model, and the ports are in the "spannning-tree edge-port" configuration.
When the port with this same configuration change (turn off), the switch send STP topology changes to the others switches. And this do to the network go down.
Can you help me?
Regards!
We have a switch Zyxel GS2220-50HP model, and the ports are in the "spannning-tree edge-port" configuration.
When the port with this same configuration change (turn off), the switch send STP topology changes to the others switches. And this do to the network go down.
Can you help me?
Regards!
0
All Replies
-
Hi @giruffato,
Is your GS2220-50HP in standalone mode or Nebula mode?
Could you share your topology and which ports did you enable "spanning-tree" & "spannning-tree edge-port"?
Zyxel Melen
0 -
Hi @giruffato,This is because that port is a non-edge port. The port with edge port setting will change to non-edge port status when it connects with a device that sends BPDU.In addition, if your topology is bus topology and won't become a ring topology, you might consider disabling STP and enabling Loop Guard for preventing loops.
Zyxel Melen
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 78 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 908 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight