WAC6503D-S power problem with Cisco Switch WS-C2960X-24PD-L [solved]

Zyxel_Joslyn

Hi @norwegiansalmon,

Do you only need the DF of WAC6303 or need another controller DF?
Thanks.

Joslyn

norwegiansalmon

Zyxel_Joslyn said:

Hi @norwegiansalmon,

Do you only need the DF of WAC6303 or need another controller DF?
Thanks.

Joslyn

Hi,

We are using a VPN100 as a controller for the WAC6303's and wish to continue doing so.

I suppose I would just need the firmware for the WAC6303 so I can distribute and apply it through the VPN100 using the command "capwap firmware-update source DF-Firmware".

The only problem we are experiencing is that the AP's only gets limited power and not Full.

Thanks

Zyxel_Joslyn

Hi @norwegiansalmon,

Already send you the DF link via the private message. Please check your inbox and let me know if it helps.
Thanks.

Joslyn

amra

Hi,

Same problem with WAX510D with Cisco 2960X-48LPS-L (370w). 8 units deployed and appears with "limited power" in nebula power mode. Tryied to disable CDP and force ports to 30w consumption.

Any solution for that?

Thanks

Zyxel_Joslyn

Hi @amra

Can you help to check if there is an option as "LLDP-MED" on the Cisco switch? This option should be enabled to let the power negotiation smoothly. If possible, can you provide us your org/site name and enable ZYXEL support(HELP>Support request) for us? We will check the power mode.

Joslyn