ZLD4.73 & ZLD5.36 patch 2 Official Version Released to address Buffer Overflow Issues

alexey

https://community.zyxel.com/en/discussion/comment/52596#Comment_52596

Hi. Have same issue on ATP 800 and old 1100 devices.

In my situation help change preshared key on both devices.

"Helps only change Authentication method on both side. If it was certificate, than change on preshared key, Or vice versa."

I wrote in topic

https://community.zyxel.com/en/discussion/2893/ipsec-via-main-gw-stops-work-found-old-outbound-spi-error-in-debug-log

Zyxel_James

@MarekSK EOL devices (3.30) are not affected.

@Boiler1976 yes, please upgrade to 4.73Patch which we already provide the downlink in this article.

@alexey This thread is referring to the urgent buffer issue, we will work on your case in your article thread.

EdwinSantana70009

Hi @nielsscheldeman,

In my case, I still have the same problem, even if the update is installed, my USG210 firewall keeps blocking the entire network, and I must be disconnecting it from the electricity because I can't access it and my network environment is down.

overlink

Buongiorno,

Ho problemi con USG20-VPN con la connessione VPN ho provato ad accedere via web al firewall e subito mi propone l'aggiornamento al firmware 5.36 però dopo aver avviato la procedura alla fine l'operazione non va mai a buon fine

Come posso risolvere?

mtaghadosi

https://community.zyxel.com/en/discussion/comment/52908#Comment_52908

I have the same issue I have FLEX 100 and I updated it to last version but I still have the connection problem it keeps blocking the entire network for example in 1 minute i got disconnected again and again

mtaghadosi

We updated our USG FLEX 100 to V5.36(ABUH.2) why we still have connection issues ?

electsystech

I'm getting the 504 Gateway timeout on a USG 20VPN router that had the 5.36 Patch 2 applied last week. I suspect there's another vulnerability or the patch wasn't completely effective. I'll have to do more testing.

Zyxel_James

@electsystech I would like to follow up your case, I've contact you through private message, please check your inbox, thanks

EdwinSantana70009

Hi @Zyxel_James

In my case, I still have the same problem, even if the update is installed, my USG210 firewall keeps blocking the entire network, and I must be disconnecting it from the electricity because I can't access it and my network environment is down.

Please contact me

DavidDeLaet

Hi,

We are getting the same reports, devices who get unresponsive and need a reboot. Also after 5.36 p2.

Regards,