XS3800-28 jumbo frame

Smartqwerty

Hello
I have an XS3800-28 switch with the latest firmware. How can I enable jumbo-frame for use in one of the vlans (vlan for esxi and storage iSCSI traffic).

Zyxel_Melen

Hi @Smartqwerty,

But can i check this in switch web or cli?

» You cannot check the jumbo frame status via web GUI or CLI since it is always enabled.

And what is maximal MTU? I didnt found this in references.

» XS3800 supports 12K jumbo frame for 10G and 9K jumbo frame for 2.5G.

Zyxel_Melen

Hi @Smartqwerty,

XS3800 enables jumbo-frame by default, you don't need to config it.

Smartqwerty

https://community.zyxel.com/en/discussion/comment/56045#Comment_56045

Hello
But can i check this in switch web or cli?
And what is maximal MTU? I didnt found this in references.

Zyxel_Melen

Hi @Smartqwerty,

But can i check this in switch web or cli?

» You cannot check the jumbo frame status via web GUI or CLI since it is always enabled.

And what is maximal MTU? I didnt found this in references.

» XS3800 supports 12K jumbo frame for 10G and 9K jumbo frame for 2.5G.