How to monitor and configure the DHCP clients of the USG FLEX/ATP?
Options
Zyxel_James
Posts: 624 Zyxel Employee
in Networking
Question: How to monitor and configure the DHCP clients of the USG FLEX/ATP?
Go to Monitor > Network Status > DHCP table
- Select the interface you would like to configure, and click Search
- Tick the DHCP client you would like to operate, and click the operation you want.
Release:
It allows you to remove a DHCP device from the DHCP table by releasing the IP address, and it will get a new one once it reconnects again.
Reserve:
It allows you to give a specific client a fixed IP address, which means the device will always get the same IP address as it has now. You will see the state of Static becomes yes.
Unreserve:
It means you unreserve the IP address for the DHCP client that already reserves the IP address. You will see the state of Static becomes no.
Export:
It allows you to export a CSV file with the list you tick in your DHCP table.
0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 918 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 920 Nebula FAQ
- 422 Security FAQ
- 237 Switch FAQ
- 208 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight