LINK STICKING OPTION

ObiettivoInformatica
Posts: 4
Freshman Member




Hi,
I've an ZyWall USG 60 with firmware 4.31 (AKKY.1) and I can't find the option "link sticking" under the Trunk section.
Someone could help me to find it out?
Many Thanks.
Kind Regards,
Andrea
I've an ZyWall USG 60 with firmware 4.31 (AKKY.1) and I can't find the option "link sticking" under the Trunk section.
Someone could help me to find it out?
Many Thanks.
Kind Regards,
Andrea
0
Accepted Solution
-
In 4.32 and later versions, link sticking is enabled by default.
There is no configuration for link sticking on GUI or CLI.
You can use the command to show link sticking cache for each IP.
Router> debug show ip link-sticking cache
5
All Replies
-
In 4.32 and later versions, link sticking is enabled by default.
There is no configuration for link sticking on GUI or CLI.
You can use the command to show link sticking cache for each IP.
Router> debug show ip link-sticking cache
5 -
Hi, @Zyxel_Emily,
thank you for your answer.
I've have another question.
It is possible to assign a fixed WAN (1 or 2) to a fixed PC in the office?
Exmple:
PC1 -> always WAN1
PC2 -> always WAN2
Many Thanks,
Andrea0 -
Hi @Andrea,
You can create a policy route as follows.
Incoming - interface lan[x]
Source- PC1’s IP address
Next-hop - Type Interface, Interface - wan1
SNAT - outgoing-interface
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 165 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight