LINK STICKING OPTION
Options
ObiettivoInformatica
Posts: 4
Hi,
I've an ZyWall USG 60 with firmware 4.31 (AKKY.1) and I can't find the option "link sticking" under the Trunk section.
Someone could help me to find it out?
Many Thanks.
Kind Regards,
Andrea
I've an ZyWall USG 60 with firmware 4.31 (AKKY.1) and I can't find the option "link sticking" under the Trunk section.
Someone could help me to find it out?
Many Thanks.
Kind Regards,
Andrea
0
Accepted Solution
-
In 4.32 and later versions, link sticking is enabled by default.
There is no configuration for link sticking on GUI or CLI.
You can use the command to show link sticking cache for each IP.
Router> debug show ip link-sticking cache
5
All Replies
-
In 4.32 and later versions, link sticking is enabled by default.
There is no configuration for link sticking on GUI or CLI.
You can use the command to show link sticking cache for each IP.
Router> debug show ip link-sticking cache
5 -
Hi, @Zyxel_Emily,
thank you for your answer.
I've have another question.
It is possible to assign a fixed WAN (1 or 2) to a fixed PC in the office?
Exmple:
PC1 -> always WAN1
PC2 -> always WAN2
Many Thanks,
Andrea0 -
Hi @Andrea,
You can create a policy route as follows.
Incoming - interface lan[x]
Source- PC1’s IP address
Next-hop - Type Interface, Interface - wan1
SNAT - outgoing-interface
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight