Why my LACP connection is not up?
Options

Zyxel_Chris
Posts: 739
Guru Member





If your Link Aggregation Control Protocol (LACP) connection is not coming up, it could be due to several reasons. Here's a checklist of things to consider and troubleshoot:
- LACP Configuration Matching:
- Ensure that LACP is configured consistently on both ends of the link. The LACP mode (Active or Passive) and key must match on both sides.
- Cable and Physical Connection:
- Confirm that the cables are securely connected to the correct ports on both devices. Check for any physical damage to the cables or connectors.
- Port Speed and Duplex Settings:
- Verify that the speed and duplex settings on both ends of the link match. Inconsistent speed or duplex settings can prevent the link from coming up.
- Check device configuration: you can also SSH to the device and "show run" to confirm that the device is actually applying the configuration from NCC.
For this instance, I have aggregate port 9 and 10 as trunk and port 11 and 12 as another trunk, and the configuration are applied to the device.
0
Categories
- All Categories
- 439 Beta Program
- 2.7K Nebula
- 191 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 468 USG FLEX H Series
- 308 Security Ideas
- 1.6K Switch
- 82 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 281 Service & License
- 440 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight