wan failover at flex200HP

Options
Mathije
Mathije Posts: 5
First Comment
edited January 6 in Security

I can't find instructions how to setup wan failover for the flex200 HP

only option in trunk is weighted round robin?

can someone help me?

Accepted Solution

  • PeterUK
    PeterUK Posts: 2,856  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited January 7 Answer ✓
    Options

    wan failover currently can't be done by routeing and should be possible to do ARP failover in trunking.

    Make a new User-Defined Trunk add in WAN set one the active the other to Passive

    You then may need to make a routing rule for next hop trunk you have made

    their is also interface pinging check that you can enable

    Edit: testing here shows it working as said above you you need interface pinging check on active WAN when it fails it changes to the Passive WAN then when active WAN is up you switch back for new connections

All Replies

  • PeterUK
    PeterUK Posts: 2,856  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited January 7 Answer ✓
    Options

    wan failover currently can't be done by routeing and should be possible to do ARP failover in trunking.

    Make a new User-Defined Trunk add in WAN set one the active the other to Passive

    You then may need to make a routing rule for next hop trunk you have made

    their is also interface pinging check that you can enable

    Edit: testing here shows it working as said above you you need interface pinging check on active WAN when it fails it changes to the Passive WAN then when active WAN is up you switch back for new connections

  • Mathije
    Mathije Posts: 5
    First Comment
    Options

    thnx i am not a it pro so i try to set this. (i dont understand it yet but try to work it out)

Security Highlight