Basic configuration. LAN1 -> WAN interface to go online

GMV

Hello, I have a basic doubt regarding the configuration of usg40w. I have an ISP router with 1 port enabled with an IP 217.x.x.x. If I connect a PC and indicate an IP of the 217.x.x.x range that the ISP tells me, I can go online.

Connect the WAN port of the zyxel to the port enabled by the ISP on your router, and configure the IP, mask and gateway data in the WAN interface. On the other hand, the interlace LAN1 makes DHCP server for private ip 192.168.1.X. The problem is that I can not get PCs to go online connected to Zyxel on ports 2, 3 and 4 that are mapped to the LAN1 interface.

What additional configuration would be necessary to be able to go online? I tried with a static route 192.168.1.1/255.255.255.255/ to next step WAN.

Thank you very much for reading the message and I hope that some of you can share your knowledge and experience.

PeterUK

Remove the static route you don't need that.

The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance

so try this go to network > routing > policy route

add

incoming: interface

please select one member : Lan1

next-hop

type: interface

interface: wan1

address translation

source network address translation: outgoing-interface

GMV

Thanks for the help, I tried to configure it in this way and it works correctly.

PeterUK

Remove the static route you don't need that.

The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance

so try this go to network > routing > policy route

add

incoming: interface

please select one member : Lan1

next-hop

type: interface

interface: wan1

address translation

source network address translation: outgoing-interface

GMV

Thanks for the help, I tried to configure it in this way and it works correctly.