Multi VLAN configuration on single port XMG1915-10EP
Hello everyone, I own an XMG1915-10EP switch and an NWA50AX access point. In my AP, I have configured 2 SSIDs, one for LAN with VLAN ID 10 and one for GUEST with VLAN ID 30. In the switch, I have connected the access point to port 1, and in port 2, I have connected my opnsense firewall in which I have configured VLAN 10 and 30 with their respective DHCP. I would like to understand how to configure the switch to make these VLANs 10 and 30 visible only to ports 1 and 2. Additionally, I would like to understand how to configure the management VLAN ID of the access point to make it accessible, by default is ID 1. Thank you.
All Replies
-
Hi @DavaD ,
Based on your description, I understand that your network topology is as follows.
To meet your requirements, please navigate to the local GUI of the XMG1915-10EP, then go to Switching > VLAN > VLAN setup, and configure as indicated below. After making the changes, click 'Apply'.
By default, the management VLAN ID for the access point is set to ID 1 is done.
Be a Community MVP: Win a VIP Deal Dash on Your Next Zyxel Purchase!
0
Categories
- All Categories
- 392 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 81 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 907 Nebula FAQ
- 415 Security FAQ
- 236 Switch FAQ
- 206 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 138 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight