DDNS in V1.20 for 2024-04-18 14:10:29 problems
Options
PeterUK
Posts: 2,806 Guru Member
I'm sure DDNS was working fine in V1.20 2024-04-15
So I have three WAN's VLAN443, WAN2 and WAN3 if all three are on line WAN2 tries to DDNS sends a SYN gets a SYN ACK then it RST it but if I remove WAN3 then DDNS for WAN2 works
It will work on a reboot then if you disable/enable the DDNS for WAN2 shows fail until you uplug (or disable the interface) WAN3
0
All Replies
-
Ok I found the link to this problem if you have User-Defined Trunk using least load first Load Balancing Index(es) Outbound + inbound
VLAN443 Active
ge2 WAN2 Active
ge3 WAN3 Active
It stops DDNS on WAN2 from updating when using WRR no problem
0 -
Another problem is User custom DDNS only auto works and not Public IP but Public IP will work on a select DDNS like no ip or DynDNS
0
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 915 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight