No traffic flow through site-to-site IPSec VPN tunnel

RaphaelOIiveria
Posts: 35
Freshman Member





Hi I deployed the USG110.
All deployment was ok, but when a configured VPN site-to-site using IPsec the tunnel connect but the traffic through tunnel not is allow.
The solution was disable Control Policy, but this solution disable all rules and the traffic bitween VLANs is permmit.
I need that VPN traffic to be allow and the Policy Control enable.
I need that VPN traffic to be allow and the Policy Control enable.
Anymore had this probleme?
0
Accepted Solution
-
The VPN tunnel just deal with the routing of the traffic goes to.
You need to set the firewall rules to allow the traffic pass to.
Here the steps that you can check,
1. check the ZONE of the VPN tunnel.
2. check the security policy rule settings.
3. Add the rules to allow traffic for to and from the VPN tunnel.
6
All Replies
-
Hi.
I resolved the problem.
Whent I started the deployment i removed all default rules, include the rules that allow the traffic from VPN to ZyWall.
When i recreated the rule the traffic was normalized
Thanks all.
0
Categories
- All Categories
- 187 Beta Program
- 1.7K Nebula
- 91 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 917 WirelessLAN
- 27 WLAN Ideas
- 5.4K Consumer Product
- 173 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 452 Nebula FAQ
- 257 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight