XGS1930 - Routing trouble

PeterUK

Yes this is why I think L2 switch can't do this I know my L2+ NETGEAR M4100-D12G and L3 Cisco
SG350-10 can so its down to what switch you need.

I have a Zyxel L2 GS2210-24 which also can't do this type of routing

mauro83

https://community.zyxel.com/en/discussion/comment/66307#Comment_66307

I think the same ….you think the zyxel XGS2220 can do what i need?

PeterUK

I would hope so but maybe Melen can comment?

Zyxel_Melen

Hi @mauro83 & @PeterUK,

You don't need to set static route rules on the Zyxel switch that supports VLAN routing. Our layer 3 switch, includes XGS1930, will automatically create a routing rule after you configure an IP address to your VLAN.

You may check the IPv4 routing table. Path is Menu > Management > Routing table > IPv4 Routing table. The below screenshot is my example.

So, you only need to set the static route on the firewall:

IP 192.168.33.0/24 gateway 192.168.11.2

IP 192.168.22.00/24 gateway 192.168.11.2

mauro83

https://community.zyxel.com/en/discussion/comment/66362#Comment_66362

Thanks for the Solution!