XGS1930 - Routing trouble

2»

All Replies

  • PeterUK
    PeterUK Posts: 3,502  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Yes this is why I think L2 switch can't do this I know my L2+ NETGEAR M4100-D12G and L3 Cisco
    SG350-10 can so its down to what switch you need.

    I have a Zyxel L2 GS2210-24 which also can't do this type of routing

  • mauro83
    mauro83 Posts: 7  Freshman Member
    First Comment Friend Collector
    edited June 2024
    https://community.zyxel.com/en/discussion/comment/66307#Comment_66307

    I think the same ….you think the zyxel XGS2220 can do what i need?

  • PeterUK
    PeterUK Posts: 3,502  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited June 2024

    I would hope so but maybe Melen can comment?

  • Zyxel_Melen
    Zyxel_Melen Posts: 2,654  Zyxel Employee
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate
    Answer ✓

    Hi @mauro83 & @PeterUK,

    You don't need to set static route rules on the Zyxel switch that supports VLAN routing. Our layer 3 switch, includes XGS1930, will automatically create a routing rule after you configure an IP address to your VLAN.

    image.png

    You may check the IPv4 routing table. Path is Menu > Management > Routing table > IPv4 Routing table. The below screenshot is my example.

    image.png

    So, you only need to set the static route on the firewall:

    IP 192.168.33.0/24 gateway 192.168.11.2

    IP 192.168.22.00/24 gateway 192.168.11.2

    Zyxel Melen


  • mauro83
    mauro83 Posts: 7  Freshman Member
    First Comment Friend Collector
    https://community.zyxel.com/en/discussion/comment/66362#Comment_66362

    Thanks for the Solution!

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）