VTI bootup causes VLAN to fail

PeterUK
Posts: 3,770
Guru Member





USG FLEX200H V1.21(ABWV.0)
P4 VLAN47192.168.255.39 255.255.255.240
VTI Route-based
IP 192.168.254.9
Pre-Shared Key 12345678
Phase 1 AES128 SH256 DH2
Phase 2 AES128 SH1 DH2
VTI IP 192.168.255.42 255.255.255.240
Nailed-up
On bootup clients onVLAN47 have no internet ping to 1.1.1.1 fails
workaround go to network > interface > advanced setting disable/enable the VTI
Also uptime might be a problem
0
Accepted Solution
-
Odd testing again its not doing this must of not waited after boot shows good long enough
0
All Replies
-
Odd testing again its not doing this must of not waited after boot shows good long enough
0 -
I think it was a case of the flex shows as ready LAN client gets a IP ping fails for a minute then works
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 165 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight