How to connect a Nebula AP to NCC when controller controls it?

Zyxel_Ivan
Posts: 317
Zyxel Employee





Question: How to connect a Nebula AP to NCC when controller controls it?
Answer: If the Nebula AP is controlled by controller, you need to remove the Access Point (AP) from the controller and ensure that the NCC Discovery setting is enabled. Here's how:
- Remove the AP from the controller by clicking the icon shown.
- Follow the directions in this forum post to enable NCC Discovery.
Once these steps are completed, your device should connect to Nebula successfully.
0
Categories
- All Categories
- 415 Beta Program
- 2.5K Nebula
- 152 Nebula Ideas
- 102 Nebula Status and Incidents
- 5.8K Security
- 300 USG FLEX H Series
- 283 Security Ideas
- 1.5K Switch
- 77 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.5K Consumer Product
- 254 Service & License
- 396 News and Release
- 85 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.7K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 87 About Community
- 76 Security Highlight