ZyWALL IPSec VPN Client

steve15f

hi everybody,

i've installed ZyWALL IPSec VPN Client to do a VPN connection with a ZyWALL 370 VPN.

Kind of connection is IKEv2. but, i've a question with the VPN configuration, i should give an IP (client VPN address) otherwise the ZyWALL IPSec VPN Client get an IP : 10.20.20.10. I don't understand why, where are from this IP 10.20.20.10. Is it possible to setup a range of IP address in the VPN and where ? I would like that the ZyWALL IPSec VPN Client get an IP like 192.168.253.0/24 range 

The second thing is that i have several IPSec VPN tunnel (site to site) and when i connect the ZyWALL IPsec VPN Client without client VPN address (0.0.0.0), the client get the IP 10.20.20.10, i don't know why but i've a VPN site to site who fall the connection (only one) .

Thanks a lot.

Zyxel_Stanley

Hi @steve15f

Welcome to Zyxel community.:) 

If you would like to get IP address from ZyWALL, then you must enable EAP in VPN Gateway(phase 1) and configuration payload in VPN Connection(Phase 2).

ZyWALL Phase 1: extended Authentication Protocol

ZyWALL Phase 2: Configuration Payload

IPSec VPN Client Phase 1:

IPSec VPN Client Phase 2:

After tunnel established, then you will get IP address and remote LAN subnet automatically.

Zyxel_Stanley

Hi @steve15f

Welcome to Zyxel community.:) 

If you would like to get IP address from ZyWALL, then you must enable EAP in VPN Gateway(phase 1) and configuration payload in VPN Connection(Phase 2).

ZyWALL Phase 1: extended Authentication Protocol

ZyWALL Phase 2: Configuration Payload

IPSec VPN Client Phase 1:

IPSec VPN Client Phase 2:

After tunnel established, then you will get IP address and remote LAN subnet automatically.

steve15f

Thanks a lot