USG60 unresponsive GUI and ZySH Daemeon Busy
Hi,
I have a problem with my USG60 device. When I log in to the router via GUI it sometimes becomes unresponsivce for a while. I often then got an error message "Wrong CLI command, device timeout or device logout." and I have "ZySH daemon is busy" in error log. After a while GUI becomes responsive for a minute or two and problem occurs again.
I've found few simmilar topics on the forums but there were no solution there.
Thanks in advance for any advice.
Accepted Solution
-
Hi @relains,
May I know if your USG60 has upgraded to the latest firmware version? If it is not V4.73(AAKY.2), please upgrade to the latest firmware version. The download link is below:
https://portal.myzyxel.com/my/firmwares?fw_version=4.73(AAKY.2)C0&model=USG60
In addition, USG60 has been EOL, you may consider migrating your USG60 to USG FLEX 200.
Zyxel Melen0
All Replies
-
Hi @relains,
May I know if your USG60 has upgraded to the latest firmware version? If it is not V4.73(AAKY.2), please upgrade to the latest firmware version. The download link is below:
https://portal.myzyxel.com/my/firmwares?fw_version=4.73(AAKY.2)C0&model=USG60
In addition, USG60 has been EOL, you may consider migrating your USG60 to USG FLEX 200.
Zyxel Melen0 -
Yes it has latest firmware.
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 165 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight