how to use two different providers

davide_mds

Hi,
I have an USGFLEX50 to which I would like connected two different internet providers: FASTWEB connected to the WAN port and VODAFONE connected to the WAN2 port.

I would like to create two internal networks with different address classes: LAN (192.168.0.0/24) and VLAN (192.168.10.0/24)

I would like LAN uses WAN (FASTWEB) and VLAN1 uses WAN2 (VODAFONE)

I created two wifi in the external controller that manages the wireless networks, wifi_office should connect to LAN and wifi_production should connect to VLAN.

Is it possible? How can I do it?

Thank you very much

Davide

PeterUK

The Flex50 only have one WAN port but you can make VLAN external off that port for another WAN you will need a VLAN switch to do this

for the switch given that both WANs will likely be untag like so

Port 3 to FLEX50 WAN

VLAN1 Forbidden port 1,2 and 3
VLAN101 FASTWEB 1 and 3 untag port 2 and other ports Forbidden
VLAN102 VODAFONE 2 untag and 3 tag port 1 and other ports Forbidden
ports 1 and 3 PVID 101
port 2 PVID 102

have a zone for wan2 for the external VLAN

make routing rules

incoming interface LAN1
next hop WAN1

incoming interface LAN2
next hop VLAN WAN2

mMontana

Does not OPT port allow WAN configuration, like this?

PeterUK

I don't think the FLEX50 has a OPT

mMontana

I took the screenshot from a RJ45-only version of a USG-Flex 50.

I the same there is in SFP+RJ45 version.