Is there an issue with the guest wifi working on the usg20w-VPN with firmware version 4.33(ABAR.0)?
I am setting this brand new FW and the wizard said it was successful in easy mode but there is no internet connection. I found a KB and followed steps to set up a policy to allow it but that did not work either.
The main wifi connection has worked from the start after a NAT rule was setup because the ISP modem is bridged over to this FW.
The main wifi connection has worked from the start after a NAT rule was setup because the ISP modem is bridged over to this FW.
0
All Replies
-
Resolved by going to Configuration > Interface > Ethernet (tab) and changing the Guest configuration zone to Guest.0
-
0
Categories
- 8.5K All Categories
- 1.6K Nebula
- 72 Nebula Ideas
- 57 Nebula Status and Incidents
- 4.5K Security
- 227 Security Ideas
- 985 Switch
- 46 Switch Ideas
- 882 WirelessLAN
- 24 WLAN Ideas
- 5.2K Consumer Product
- 158 Service & License
- 280 News and Release
- 61 Security Advisories
- 13 Education Center
- 581 FAQ
- 263 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 75 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 62 About Community
- 46 Security Highlight