Xs1930-10 flow control?

Skyeci26

Hi.

I recently bought an xs1930-10. I'm trying to establish what the default firmware setting is with regards to flow control. I can't see it in any menus on the port setup and I asked support via a question but didn't get a answer either.

Does anybody know if its on or off or doesn't exist on default setup?

I have implemented the switch within my 10gb network so am trying to establish what is the best practice with regards to flow control within a 10gb network for this switch and what it's default setting is.

Many thanks for any help

Zyxel_Judy

Hi @Skyeci26 ,

Please note: The XS1930 does not currently support Flow Control when managed through Nebula. If your Nebula switches support Flow Control, you can configure it at Configure > Switches > Switch Port.

Please refer to the table below for a list of Nebula switches that support Flow Control:

Zyxel_Judy

Hi @Skyeci26 ,

We believe that your XS1930-10 is managed by Nebula Cloud, so flow control configuration is not available locally. When an XS1930-10 is managed by Nebula, you must access the Nebula portal to implement switch settings.

Skyeci26

How though. I can't find any menus relating to flow control anywhere.

Zyxel_Judy

Hi @Skyeci26 ,

Please note: The XS1930 does not currently support Flow Control when managed through Nebula. If your Nebula switches support Flow Control, you can configure it at Configure > Switches > Switch Port.

Please refer to the table below for a list of Nebula switches that support Flow Control:

Skyeci26

OK thanks. Your chart confirms the xs1930 I have doesn't support it.